https://www.bbastrodesigns.com/25/25%20 ... ments.html
Телескоп Бартелса (на всякий случай, если кто еще не видел). Разгрузка на 9 точек, D=635mm, F=2.6, толщина
Правда стекляха вогнутая, т.е. постоянной толщины.
Модератор: Ernest
Нет, у Бартелса зеркало разнотолщинное. Исходная заготовка диаметром 25 дюймов и толщиной 3/4 дюйма, была моллирована в мениск той же толщины, но под более крутой радиус, чем требовалось для конечного зеркала. Потом вогнутая сторона мениска была обработана под более пологий радиус, так что в центре осталась исходная толщина 3/4 дюйма, а к краю толщина уменьшилась до 1/2 дюйма.Diff писал(а): ↑30 янв 2019, 11:07https://www.bbastrodesigns.com/25/25%20 ... scope.html
https://www.bbastrodesigns.com/25/25%20 ... ments.html
Телескоп Бартелса (на всякий случай, если кто еще не видел). Разгрузка на 9 точек, D=635mm, F=2.6, толщина3312.7 mm.
Правда стекляха вогнутая, т.е. постоянной толщины.
Заготовка до моллирования:The grinding procedure is then to lengthen the RoC on the front (concave) surface by grinding it back to the intended focal length (there are several ways of doing this, including a diamond cup. I haven't decided yet how I will do it). Mel stopped at f/2.5 and I'm aiming for f/2.8 or, maybe, f/2.7. This is done by thinning the periphery of the front surface by about 3/16 inch near the edge (for my 28 inch) and gradually less towards the center. The result is that the center of the blank more or less maintains its original ¾ inch thickness and the edge is now down to near ½ inch thick. The back of the blank maintains its strongly curved f/2 shape which helps in providing the structural strength of the meniscus.